Resetting and Configuration Of WA3002 Modem
Do you like this story?
Forgot ur Authentication Password - Stuck with ur Modem.
About Author
This post was written by a Zaheer Hussain Admin Of Innovate Bloggers. If you'd like to guest post for innovatebloggers check out our Post Article page for details about how YOU can share your tips with our community.Catch Him On Facebook
No Problem i have the easy ways to clear u..
- Power on ur Modem ,when all light glow press the Reset Button back of ur Modem continuously for 10 - 15 seconds.
- Then Switch off the power,dont take ur hand from the reset button.Hold it for another 10 seconds.
- Now remove ur hand from the reset button and switch on the modem again.
- Now type 192.168.1.1 in the address bar and type the default username and password as "admin".
Now we shall come to the configuration.
- Under Interface Setup --> Choose Internet section.
- Choose Virtual Circuit as PVC0
- Status: Activated
- Range: 0 - 35.
- Select ISP address as : PPPoA/PPPoE.
- Then type ur username and password given by the service provider.
- Then come below u will see the..TCP MTU option : the default value will be 1500.You can set to 0 ,but after setting this value some sites cant be open if u face this problem , change the value to 1492 or 1454.
Now Select Advanced setup ---> ADSL
- Choose ADSL mode as AutoSync- up.
- Then under Maintenance tab Select SysRestart and Restart ur modem.
Thanks for reading this post.Hope it will be useful for u..
About Author This post was written by a Zaheer Hussain Admin Of Innovate Bloggers. If you'd like to guest post for innovatebloggers check out our Post Article page for details about how YOU can share your tips with our community.Catch Him On Facebook
Subscribe to:
Post Comments (Atom)
0 Comments “Resetting and Configuration Of WA3002 Modem”
Post a Comment